溫州環氧保潔告訴您環氧保潔基面
環氧保潔 - 基面要求
1.含水率小于6%無油污，外表干燥，PH值應在6.0-8.0。新做保潔，水泥保潔養護期28天過后進場，施工前5天，基層不能再用水沖洗或被濕潤。
2.應杜絕砂漿起殼現象，水泥基面牢固、結實、不起殼，混凝土層與砂漿找平層好一起澆筑。 
3.若先澆筑混凝土層，則要求砂漿層的厚度不低于40mm，對叉車道的要求則更厚。
4.有關坡度應符合設計要求，允許偏差值為溫州溫馨保潔公司坡度的2%并且不大于30mm。
5.硬度高，要求外表不起砂。沒有水泥粉化現象。新澆筑的水泥砂漿層要充分保養。
6.水泥基面平坦，無凹凸不平、蜂窩、麻面、水泥疙瘩、其他涂料、防銹漆、乳膠漆、瀝青等殘?jiān)?
Epoxy mortar floor - base level requirements
1. The moisture content of less than 6% without oil, appearance is dry, PH value should be 6.0 to 8.0. New do floor, cement floor maintenance period of 28 days after the play, five days before the construction, basic can't wash with water or wet.
2. Should put an end to mortar shell phenomenon, cement base surface, solid, solid, not shell with mortar screed-coat best pouring concrete layer.
3. If the concrete layer first, insist on not less than 40 mm mortar layer thickness, demand for forklift way is more thick.
4. About the slope should comply with the design requirements, allowing the deviation value of slope and no greater than 2% of the 30 mm.
5. High hardness, appearance can't afford to sand. No phenomenon of cement powder. To fully maintain the new pouring cement mortar layer.
6. Cement base surface smooth, no uneven, voids, pits and cement bumps and other residue of paint, antirust paint, latex paint, asphalt, etc.
http://www.yuxiuhua.cn/spb0/04e9-13.htm |
